Skip to content
IkonaBIT Instruments written by musicians, for musicians. Sign in

Flanger

Rheos Lite

Rheos Lite

A classic flanger with RATE, DEPTH, FEEDBACK, MIX and tempo sync. What is not on the panel stays at the factory values of the full version, so the sound you start from is the right one. The FREE edition keeps the same delay line, the same latency and the same bypass.

v1.0.1

Available forVST3 · StandaloneVST3 · Standalone
Rheos Lite
Four knobs, a sync switch and the bypass.

FREE

Download FREE

v1.0.1

Available forVST3 · StandaloneVST3 · Standalone

FREE forever: no purchase, no time limit. To unlock it you need an account: get your FREE licence there, enter your computer's machine code and you receive the licence file for that computer. Until then the plugin runs in demo mode, like every ikonaDSP plugin. Both formats included.

Fewer controls, not a different chain.

Rheos Lite is built from the same source as Rheos. The reduction is in what you can adjust, not in the quality of the engine: in the Lite's own test, the controls it does not use can be set to extreme values and the output does not change by a single bit.

The controls

Four knobs, a sync switch and the bypass.

Everything else sits at the factory values of the full version: classic mode, sine LFO, a 1 ms base delay, a stereo phase of 90 degrees, positive polarity, no filter in the loop and 0 dB output.

RATE and SYNC

RATE covers 0.01-10 Hz when free, or locks to the host tempo on 15 divisions. With SYNC on, the knob chooses the division instead of the frequency.

DEPTH and FEEDBACK

The delay runs from 1 ms up to 8 ms at full depth. Feedback goes from -95 to +95 %: positive for peaks, negative for a hollow comb.

MIX

Dry to wet, from 0 to 100 %. At 100 % with no feedback there is no comb, only a modulation of pitch.

Who it is for

For the classic sweep, at no cost.

A flanger is often needed once or twice in a mix. This one starts from a good sound and keeps the panel to what changes it.

A starting point that is right

A base delay of 1 ms puts the first notch at 500 Hz, and the factory presets are written for this panel.

Sessions that move

A session saved with Rheos opens in the Lite, which ignores what it does not offer; one saved in the Lite opens in Rheos with nothing lost, because the missing parameters return to their defaults.

No strings

The FREE edition has no trial, no time limit and no noise bursts. User presets are saved and opened as in the full version.

What the full Rheos adds

The same flanger, with more around it.

Rheos shares this edition's delay line, latency, bypass and A | B, and a session moves between the two. It adds the following, with 20 factory presets written for it.

Through-zero

The wet signal passes in front of the dry one; with polarity at minus the sound cancels at the crossing.

Base delay

MANUAL: 0.4-5 ms, where this edition is fixed at 1 ms.

Five LFO shapes

Sine, triangle, saw, square, and sample and hold, where this edition has the sine.

A filter in the loop

From 500 Hz to 20 kHz: each pass of the loop loses treble.

Stereo phase and polarity

Stereo phase from 0 to 180 degrees, where this edition is fixed at 90, and plus or minus polarity.

Output level

From -12 to +12 dB, to compensate a high feedback; this edition stays at 0 dB.

The comb

The curve is the real state of the flanger.

The display is computed from the running delay, feedback and mix at every block, not drawn: left channel in colour, right channel faint, from 20 Hz to 20 kHz on a logarithmic or linear scale. With a delay of 1 ms the first notch is at 500 Hz. Each column shows the true minimum and maximum of the comb over the band it covers, so narrow notches are not lost.

  • The delay runs from 1 ms up to 8 ms at full depth
  • Feedback from -95 to +95 %, with the loop filter off
  • The slope of the sweep is limited to 0.15 samples per sample: above 5.43 Hz, full depth on a sine is reduced, because a delay that moves too fast would shift the pitch again on every pass of the loop
The curve is the real state of the flanger.

What was left out

No through-zero, no loop filter, no base delay.

The reduction sits where the value of the full version is: through-zero, the choice of LFO shape, the filter in the loop, the stereo phase and the base delay. There is no polarity and no output level either. With a high feedback the level rises, and the Lite has no OUTPUT to compensate: lower it at the channel fader of the track. Nothing here is a time limit or a nag.

The panel

Four boxes, nothing that does not sound.

The top bar is the one shared by the whole effects line: presets with their arrows, A | B, BYPASS, OPTIONS. Under it the comb display and the IN and OUT meters, then four boxes: SWEEP with RATE and DEPTH, FEEDBACK, OUTPUT with MIX, and SYNC with FREE and SYNC and the division. The panel does not show what the Lite does not play: a control you turn that changes nothing is worse than a control that is absent.

  • A | B: two complete copies of the sound, saved with the session
  • Panel of 1200 x 580, scalable from 50 to 200 %
  • 8 factory presets, also exposed as host programs

What is measured

The same 5.33 ms as the full version.

The latency is 256 samples at 48 kHz in every case: it does not depend on the parameters or on the block size, and it is the same in bypass. The Lite pays the latency that the full version needs for through-zero, so the same session opens in both without anything moving.

256samples of latency at 48 kHz, always
8factory presets, each checked against a stored baseline
143checks in the shared engine test, 0 failed
8 msmaximum delay, at full depth

The parameter list is the same as in Rheos, so that sessions move between the editions: the host lists all 14 parameters, the Lite reads 7 of them and ignores the other 7, which the panel does not show. The bypass replaces the output with the dry signal delayed by the declared latency, with a 10 ms fade, and the flanger keeps running underneath.

Specifications

TypeStereo flanger, classic mode
DelayFrom 1 ms to 8 ms at full depth, fixed base delay
LFOSine, 0.01-10 Hz free or locked to the host tempo on 15 divisions
Feedback-95 to +95 %, filter in the loop off
Stereo phase90 degrees, fixed
Latency256 samples at 48 kHz (5.33 ms), constant, the same as Rheos, also in bypass
BypassThe dry signal delayed by the same latency, 10 ms fade
ParametersThe 14 of Rheos, same identifiers: the Lite reads 7 and ignores 7
Presets8 factory presets, its own bank, also exposed as host programs, plus user presets on file
Panel1200 x 580, four boxes, scalable from 50 to 200 %; A | B
LicenceFREE and perpetual: licence file from your account, tied to your computer
FormatsVST3 and standalone on Windows 64-bit and macOS; mono or stereo in and out, mono to stereo

In short

The flanger, FREE.

Five controls, 8 presets and a 5.33 ms latency, from the same engine as Rheos.

The other instruments

Downloads

Try Rheos Lite

Windows downloads are installers (.msi, or the .exe inside a ZIP); macOS downloads are .pkg installers.

Rheos Lite

Rheos Lite

The flanger, with the essential controls

A classic flanger with RATE, DEPTH, FEEDBACK, MIX and tempo sync. What is not on the panel stays at the factory values of the full version, so the sound you start from is the right one. The FREE edition keeps the same delay line, the same latency and the same bypass.

Read about this instrument

All installers